1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Superman185
    Thread

    Unresolved Printing issues with a curved side

    I have been trying to figure this problem through these threads and a few websites that give advise on how to correct common print issues....
    Thread by: Superman185, May 11, 2021, 1 replies, in forum: Troubleshooting
  2. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    I will be adding a 6 pin, molex connector so this can't happen again :rolleyes: [ATTACH]
    Post by: Superman185, May 6, 2021 in forum: Troubleshooting
  3. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    I did trace the ports on the site schematics that you gave me from the arduino site and I remember A13-15 goes directly to the CPU IC. There are...
    Post by: Superman185, May 6, 2021 in forum: Troubleshooting
  4. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    The fun part is that the old arduino board has no visible signs of damage from this issue. It must be contained within the IC processor.
    Post by: Superman185, May 6, 2021 in forum: Troubleshooting
  5. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    So it was for sure the Arduino board not the RAMPS or the hot plate. The new arduino board shows the temp accurately. Good to know for future...
    Post by: Superman185, May 6, 2021 in forum: Troubleshooting
  6. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    Gotcha, thank you. Why don't you like auto leveling?
    Post by: Superman185, May 2, 2021 in forum: Troubleshooting
  7. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    Thank you for the info. Well the board is different that is listed on the site, this is the one I bought and was previously installed; partsbuilt...
    Post by: Superman185, May 2, 2021 in forum: Troubleshooting
  8. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    Well bad news... the problem isn't with the ramps board. I changed the ramps board and the hot plate so the problem must reside with the arduino...
    Post by: Superman185, May 1, 2021 in forum: Troubleshooting
  9. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    Good to know. Thank you Tomlinson I get my new parts on Monday so by the weekend I should have it all up and running.
    Post by: Superman185, Apr 29, 2021 in forum: Troubleshooting
  10. Superman185
    Post

    Solved Commands to calibrate the bed temperature

    I see the temp in matter control After more tinkering last night I found that the mainboard (RAMPs board) is the problem, I was just too...
    Post by: Superman185, Apr 27, 2021 in forum: Troubleshooting
  11. Superman185
    Thread

    Solved Commands to calibrate the bed temperature

    I just bought a Robo 3D R1 + V2 printer used and with a bed modification from partsbuilt (Heated Glass Build Plate for R1+) and the temperature...
    Thread by: Superman185, Apr 26, 2021, 20 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again