1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Simonpackman1
    Post

    Unresolved X issues

    also the toothed gear on the stepper is tight. I was also guessing maybe the stepper is going bad... I use simplify 3D and this just randomly...
    Post by: Simonpackman1, May 5, 2016 in forum: Troubleshooting
  2. Simonpackman1
    Post

    Unresolved X issues

    I've noticed its not always the first layer. Sometimes it goes in and out. How would I fix belt slip?
    Post by: Simonpackman1, May 5, 2016 in forum: Troubleshooting
  3. Simonpackman1
    Post

    Printer Dimensions

    i don't have solid works... I use autocad. I'm a Civil Engineer...
    Post by: Simonpackman1, May 5, 2016 in forum: General Questions
  4. Simonpackman1
    Thread

    Printer Dimensions

    does anyone know the distance between the two smooth support rods on the z-axis. I was hoping someone had an accurate dimension. I am planning...
    Thread by: Simonpackman1, May 5, 2016, 5 replies, in forum: General Questions
  5. Simonpackman1
    Post

    Unresolved X issues

    no, its offset and its not the skirt.
    Post by: Simonpackman1, May 5, 2016 in forum: Troubleshooting
  6. Simonpackman1
    Post

    Unresolved X issues

    here is an image of the offset
    Post by: Simonpackman1, May 4, 2016 in forum: Troubleshooting
  7. Simonpackman1
    Post

    Unresolved X issues

    When facing the printer the x axis jogs left and right. My first layer is offset a small amount and thereafter all of the layers are aligned...
    Post by: Simonpackman1, May 4, 2016 in forum: Troubleshooting
  8. Simonpackman1
    Thread

    Unresolved X issues

    MY x axis is offset on the first layer for some reason. Any advice?
    Thread by: Simonpackman1, May 1, 2016, 12 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again