1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. John Coble
    Post

    Unanswered R1 printer not printing to any level of quality after storage and leadscrew upgrade.

    The extruder was already calibrated to an exact. Switched over to matter controller to see if something in my cura was off and im getting better...
    Post by: John Coble, Jun 13, 2021 in forum: Troubleshooting
  2. John Coble
    Post

    Unanswered R1 printer not printing to any level of quality after storage and leadscrew upgrade.

    Let me attach a picture to give you a better idea of the lead screw upgrade Ive done. [IMG] Used the popular bangood 8mm lead screws [IMG]...
    Post by: John Coble, Jun 13, 2021 in forum: Troubleshooting
  3. John Coble
    Thread

    Unanswered R1 printer not printing to any level of quality after storage and leadscrew upgrade.

    Howdy from Texas! I've recently brought my R1 out from storage as I finally had space for a printer again! I have been tweaking and working at...
    Thread by: John Coble, Jun 13, 2021, 4 replies, in forum: Troubleshooting
  4. John Coble
    Post

    Answered R1 printer with marlin firmware unresponsive to z-offset changes.

    Ill play with UBL thanks a bunch! Been around 4 years since this printer ran and im trying to dial it back in, ran into alot of issues.
    Post by: John Coble, May 23, 2021 in forum: Troubleshooting
  5. John Coble
    Post

    Answered R1 printer with marlin firmware unresponsive to z-offset changes.

    Ahhh I see, I knew the nozzle was the probe and didn't require an offset, but everywhere I looked to had me changing it. I'll try UBL but from...
    Post by: John Coble, May 23, 2021 in forum: Troubleshooting
  6. John Coble
    Thread

    Answered R1 printer with marlin firmware unresponsive to z-offset changes.

    Howdy from Texas! Just a couple of days ago I decided to install some custom firmware for the good ol R1. After trying to use both version 1.1.9...
    Thread by: John Coble, May 22, 2021, 6 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again