1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. allan arthur
    Post

    Solved R1+_SP_HEXAGONHOTEND_1.75

    i switched the wires and seems to be heating fine. no i just need to readjust z offset
    Post by: allan arthur, Nov 28, 2017 in forum: Troubleshooting
  2. allan arthur
    Thread

    Solved R1+_SP_HEXAGONHOTEND_1.75

    replaced hot end with R1+_SP_HEXAGONHOTEND_1.75. from robo3d.com. now temo for hot end says 111c even before i heat up hot end how to fix.
    Thread by: allan arthur, Nov 27, 2017, 2 replies, in forum: Troubleshooting
  3. allan arthur
    Post

    Solved Octopi

    is there any special add ons i need to get ?
    Post by: allan arthur, Sep 19, 2017 in forum: Troubleshooting
  4. allan arthur
    Thread

    Solved Octopi

    has anyone used octopi with robo r1 plus? If so does it work good? I am on process of getting rasberry pi 3 and using it to controll printer.
    Thread by: allan arthur, Sep 6, 2017, 3 replies, in forum: Troubleshooting
  5. allan arthur
    Thread

    diamond hot end

    has any one thought about putting a diamond hot end on the r1 plus it has 3 in one out design. if so have you got it working i am thinking about this.
    Thread by: allan arthur, Aug 31, 2017, 2 replies, in forum: General Questions
  6. allan arthur
    Post

    Solved fleks3d print bed and gcode

    i have solved the problem. here is my start g code. G28 X0 Y0 Z0 ; home all axes G1 Z5 F5000 ; lift nozzle G28 X0 Y0 Z0 ; Home Z again in case...
    Post by: allan arthur, May 5, 2017 in forum: Troubleshooting
  7. allan arthur
    Post

    Solved fleks3d print bed and gcode

    OK if i put that after g28 and g29 pair. is g28 and g29 the bed auto leveling then just have extruder heat after that. with g codes i am lost . is...
    Post by: allan arthur, Mar 26, 2017 in forum: Troubleshooting
  8. allan arthur
    Post

    Solved fleks3d print bed and gcode

    Post by: allan arthur, Mar 26, 2017 in forum: Troubleshooting
  9. allan arthur
    Thread

    Solved fleks3d print bed and gcode

    I am wanting to get a Fleks3d print bed set. What zcode setting do i need to turn off extruder heat before auto bed leveling. Then turn on heat...
    Thread by: allan arthur, Mar 26, 2017, 5 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again