1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered “Filament has run out”

Discussion in 'Troubleshooting' started by Braylin parsons, Jun 19, 2023.

Thread Status:
Not open for further replies.
  1. Braylin parsons

    Braylin parsons New Member

    Joined:
    Jun 19, 2023
    Messages:
    1
    Likes Received:
    0
    I recently acquired the printer and every time I try to print something around at the 10% mark it says my filament has run out when I have a whole spool loaded into it. The previous owner said this has never happened to him. Has someone else had this problem and can help?
     
    #1 Braylin parsons, Jun 19, 2023
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    You must be mistaken or have a modified R1+ -- it did not have Filament Runout sensors.
     
    #2 mark tomlinson, Jun 20, 2023
  3. revlad380

    revlad380 New Member

    Joined:
    Aug 23, 2023
    Messages:
    1
    Likes Received:
    0
    With my R2 I was getting the same thing. I ran my filament through the other hole in the sensor (closes to the edge) and I haven't had an issue since. If you hadn't already solved your issue I hope that helps.
     
    #3 revlad380, Aug 24, 2023
Thread Status:
Not open for further replies.

Share This Page