1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved .8 nozzle print problems??

Discussion in 'Troubleshooting' started by Robert J., Jan 20, 2016.

  1. Robert J.

    Robert J. Member

    Joined:
    Dec 23, 2015
    Messages:
    46
    Likes Received:
    7
    This is my first print with a .8 nozzle, any thoughts on what i can do to make it better? I am using simplify3d.
     

    Attached Files:

    #1 Robert J., Jan 20, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Make sure you are getting good layers (the first one in particular).
    Did you adjust your layer heights?

    I attached a profile that I had been using for Simplify3D (with PLA and a 0.8 volcano).
    Sanity check the temps and the other settings and you might have a starting point.
     

    Attached Files:

    #2 mark tomlinson, Jan 21, 2016
  3. Robert J.

    Robert J. Member

    Joined:
    Dec 23, 2015
    Messages:
    46
    Likes Received:
    7
    Thanks Mark for file but i am unable to open it, what program do i need to open the .fff file format?
     
    #3 Robert J., Jan 21, 2016
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Simplify3D
     
    #4 mark tomlinson, Jan 21, 2016
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #5 mark tomlinson, Jan 21, 2016

Share This Page