1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

ABS WONT STICK

Discussion in 'Troubleshooting' started by Rasmus fink, Mar 22, 2014.

Thread Status:
Not open for further replies.
  1. Rasmus fink

    Rasmus fink New Member

    Joined:
    Mar 22, 2014
    Messages:
    23
    Likes Received:
    2
    I got my robo 3d 2 days ago

    at first i couldnt even get it to run any tasks, but found that i just had to turn on the cooler manually each time, (m999 error)

    so then i thought lets print something but i simply cant get the abs to stick have tried hair spray, and also tryed setting the first layer speed to 1% in slic3r any1 have some info on how i can get it to stick
     
    #1 Rasmus fink, Mar 22, 2014
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Painters tape... but in reality your first layer is probably not correct (height is off). Once I got that sorted it takes a jackhammer to remove things from the tape. It probably is just a prophylactic now for me :)
     
    #2 mark tomlinson, Mar 22, 2014
Thread Status:
Not open for further replies.

Share This Page