1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Adjusting z end stop

Discussion in 'Troubleshooting' started by mizew151, Jan 6, 2016.

  1. mizew151

    mizew151 New Member

    Joined:
    Sep 5, 2015
    Messages:
    5
    Likes Received:
    0
    I put the e3d v6 into my robo yesterday and then manually lowered the nozzle to the bed and got one good print now the nozzle stops a few millimeters above the bed and starts extruding while giving me a hit z stop warning how do I adjust the z end stop to allow my nozzle to go lower?
     
    #1 mizew151, Jan 6, 2016
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Do you have a beta printer, or an R1/R1+?

    If it's performing the autoleveling you'll need to reduce your Z offset a bit
     
    #2 Mike Kelly, Jan 12, 2016

Share This Page