1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved any ideas for bronzefill settings?

Discussion in 'Troubleshooting' started by Aura1989, Feb 20, 2015.

  1. Aura1989

    Aura1989 Active Member

    Joined:
    Aug 7, 2014
    Messages:
    126
    Likes Received:
    49
    so since i have been doing well with pla so far getting the hang of it now :)
    decided to order some bronzefill not as easy as i thought haha oh well im learning

    i get great small prints but when i try printing anything big it gets all mushy? like this stargate the first few layers print great its when it starts doing the detail its pushing it all around any ideas what im doing wrong

    im using a e3d v6 with a 4mm nozel
    220c nozzel
    60c bed
    120%flow
    rest of the settings are basic
    either a 2 or 3mm layerhight
    in cura
     

    Attached Files:

    #1 Aura1989, Feb 20, 2015
    Last edited by a moderator: Feb 20, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    I just used my standard PLA settings with the temperature a slight bit hotter (205 versus 195).
    Most was with a 0.6 nozzle, but I did do some initial tests with a 0.4
     
    #2 mark tomlinson, Feb 20, 2015
  3. Aura1989

    Aura1989 Active Member

    Joined:
    Aug 7, 2014
    Messages:
    126
    Likes Received:
    49
    with a bit more experimenting it seems i have been printing to fast i slowed it down to about 50% on the xxl screen and it seems ok but sped up to a 100 it goes all over the place hmm
     
    #3 Aura1989, Mar 30, 2015

Share This Page