1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Bed not heating properly

Discussion in 'Technical Support' started by Matthias, Nov 18, 2013.

  1. Matthias

    Matthias Member

    Joined:
    Feb 20, 2013
    Messages:
    174
    Likes Received:
    18
    #1 Matthias, Nov 18, 2013
  2. Coby Robo 3D

    Coby Robo 3D Administrator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    75
    Likes Received:
    108
    Matthias,

    We are working on resolving this issue. Some temporary fixes that others have seen success with is either putting a fan and getting airflow next to your electronics board. Or you can try separating the two big yellow fuses from each other. They are getting too hot and possibly overheating. Spreading them apart can let a little air around them to try and keep them cool. Let me know if this works.
     
    #2 Coby Robo 3D, Nov 19, 2013
  3. Matthias

    Matthias Member

    Joined:
    Feb 20, 2013
    Messages:
    174
    Likes Received:
    18
    Hi Coby,

    Leon made me aware of this the day before yesterday and I installed a small 40mm fan yesterday and it worked! I did a 1h+ print without issues.

    Gesendet von meinem Nexus 5 mit Tapatalk
     
    #3 Matthias, Nov 19, 2013

Share This Page