Cable bundle holder

Hardly an upgrade or mod.

Since most people end up permanently removing the case for better access, the cable bundle going to the extruder is not held from above. Thus it can get in the way of the moving bed or rest oon the gear(my gear has slight wear marks after only one week!).
I made this simple holder that mounts right next to the X-axis motor and holds it upright.
Uses the very convenient and unused hole next to the motor. Can use standard PC case screw.

http://www.thingiverse.com/thing:162100

 

I zip tied my bundle to the motor to keep it up and out of the way