1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Calibration issue?

Discussion in 'Troubleshooting' started by pclabtech, Jul 4, 2013.

Thread Status:
Not open for further replies.
  1. pclabtech

    pclabtech Active Member

    Joined:
    Feb 20, 2013
    Messages:
    111
    Likes Received:
    73
    I was printing out a large object at 100 microns, it is going painstakingly slow and I noticed that one side is thicker. Is the thicker side normal and the rest is not, or is the platform uneven. I want to know is my first layer is supposed to be the transparent part, or the thick part on the edge:

    http://farm3.staticflickr.com/2855/9209289019_18069aa7df_o.jpg

    [​IMG]
     
    #1 pclabtech, Jul 4, 2013
  2. Harry

    Harry Team ROBO 3D
    Staff Member

    Joined:
    Feb 13, 2013
    Messages:
    807
    Likes Received:
    180
    This seems to be a re-accuring issue. The bed leveling. I will speak about this with the team.
     
    #2 Harry, Jul 4, 2013
  3. CAMBO3D

    CAMBO3D New Member

    Joined:
    Feb 20, 2013
    Messages:
    642
    Likes Received:
    296
    this is combination of problems, unlevel bed, warping heatbed, and improper z height adjustment.
     
    #3 CAMBO3D, Jul 5, 2013
Thread Status:
Not open for further replies.

Share This Page