1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Can I 3d print a replacement part?

Discussion in 'Troubleshooting' started by PickyBiker, Feb 9, 2015.

Thread Status:
Not open for further replies.
  1. PickyBiker

    PickyBiker Active Member

    Joined:
    May 9, 2014
    Messages:
    128
    Likes Received:
    26
    The left bracket that holds the autoleveling microswitch is broken. I can use a plastic tie to hold it in place long enough to print a new bracket. Does anyone have the stl file for this bracket?
     
    #1 PickyBiker, Feb 9, 2015
  2. Quest

    Quest Member

    Joined:
    Jan 7, 2015
    Messages:
    59
    Likes Received:
    9
    #2 Quest, Feb 9, 2015
  3. PickyBiker

    PickyBiker Active Member

    Joined:
    May 9, 2014
    Messages:
    128
    Likes Received:
    26
    #3 PickyBiker, Feb 9, 2015
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Don't have one of these or I'd model you one up.
    Sorry.
     
    #4 mark tomlinson, Feb 10, 2015
  5. PickyBiker

    PickyBiker Active Member

    Joined:
    May 9, 2014
    Messages:
    128
    Likes Received:
    26
    #5 PickyBiker, Feb 10, 2015
    3 people like this.
Thread Status:
Not open for further replies.

Share This Page