1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Can't find firmware for E3D extruder!

Discussion in 'Troubleshooting' started by bcamaro1, Oct 15, 2014.

Thread Status:
Not open for further replies.
  1. bcamaro1

    bcamaro1 Member

    Joined:
    Aug 30, 2014
    Messages:
    72
    Likes Received:
    3
    I have tried to find the firmware for the temperature and found the website below. However, I'm having trouble viewing the HEX file. Does anyone know a simple download link or explain the process? I had a few prints successfully, but now it won't even heat up. So I'm assuming i just need the firmware. Can anyone point me into the right direction.


    -Bcamaro1


    http://forum.e3d-online.com/viewtopic.php?f=7&t=80
     
    #1 bcamaro1, Oct 15, 2014
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    That's for a completely different printer.

    You need the firmware for the robo right?

    Tell me about your printer, does it have a cover on the bottom? Autolevel?
     
    #2 Mike Kelly, Oct 15, 2014
  3. bcamaro1

    bcamaro1 Member

    Joined:
    Aug 30, 2014
    Messages:
    72
    Likes Received:
    3
    Yes I have the ROBO R1, I just bought it about a month ago, so I have the auto leveling.
     
    #3 bcamaro1, Oct 15, 2014
  4. bcamaro1

    bcamaro1 Member

    Joined:
    Aug 30, 2014
    Messages:
    72
    Likes Received:
    3
    I am using Repeiter-Host if that helps?
     
    #4 bcamaro1, Oct 15, 2014
Thread Status:
Not open for further replies.

Share This Page