1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cooldown

Discussion in 'Troubleshooting' started by Jaak Ahelik, Dec 14, 2017.

  1. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    Why do I get this screen in the middle of printing?
     

    Attached Files:

  2. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    You tapped on the extruder temp value and that brought up the adjustment page.
     
  3. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    No, I did not, and it dont go away also
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,672
    Likes Received:
    7,318
    Something touched the screen and triggered it.
    Some of the machines have had an issue where the edge of the touchscreen is caught by the frame and getting a false touch ...

    Which explains that as well.
     
  5. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    Going back is using the arrow on top left.

    But from the photo you seem to have some crud between the frame and touchscreen at the bottom left under the "delete" button which incidentally is where the extruder temp field is, so it's likely what's pressing the screen and triggering it.
    Just clean it up.
     
  6. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    The screen is clean, but also the delete and set buttons are blinking
     
  7. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    There was a smallll piece and it solved the problem, it was really smallll, THX
     

Share This Page