coral cuff

what setting temp/speed ect. should i use for this coral cuff? (Cura, PLA + ABS model, printing with PLA) thanks.

 

That's going to be a very challenging print to get working well. I would recommend doing a couple of calibration objects first with some starter settings (like these, though you may wish to reduce the speed by maybe 30% to start with, and I would turn off support material for both the tests and the coral cuff print or you're going to be doing a lot of cleanup), and try printing something with a lot of thin semi-vertical pieces that will tend to produce stringing, like this little pyramid. You can do several iterations of those quickly to get your settings dialed in perfectly, and have a much better chance of getting a good print the first time for the coral cuff.