1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Craftware setup

Discussion in 'Troubleshooting' started by Josh Johnston, Jan 6, 2015.

Thread Status:
Not open for further replies.
  1. Josh Johnston

    Josh Johnston New Member

    Joined:
    Dec 11, 2014
    Messages:
    11
    Likes Received:
    0
    So I read a thread about craftware and I have downloaded it and installed it. I am unable to connect to my robo on com15 I know that is the correct port it keeps saying online and busy. I don't have and other software open for my printer. Also I not sure I have entered the gcode properly. It keeps giving me errors highlighted in yellow. Does anyone have the gcode they entered in to craftware for thr robo 3d r1. Any insight would be great thanks.
     
    #1 Josh Johnston, Jan 6, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    I believe you cannot print from craftware. You need to export the Gcode from craftware into another software like MC, Repetier-Host, or LCD SD card
     
    #2 Mike Kelly, Jan 6, 2015
Thread Status:
Not open for further replies.

Share This Page