1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura Ironing Setting

Discussion in 'General Questions' started by JustinDS89, Apr 24, 2018.

  1. JustinDS89

    JustinDS89 Member

    Joined:
    Feb 20, 2018
    Messages:
    148
    Likes Received:
    21
    So I have been using the latest version of Cura with great results. I decided to try the "Ironing" setting which produces a very nice smooth top layer.

    My only problem is it pauses for a second where it starts the process and where it ends leaving two melted blobs.

    Is there a setting I can adjust that would cause it to go off the side of the print to pause or not pause at all?

    Thanks!
     
    #1 JustinDS89, Apr 24, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Not a cura user so cant help but ultimaker does have a forum as well. May peek over there and see it anyone has talked about it ?
     
    #2 Geof, Apr 24, 2018
  3. JustinDS89

    JustinDS89 Member

    Joined:
    Feb 20, 2018
    Messages:
    148
    Likes Received:
    21
    Awesome, I will check there. Thanks!
     
    #3 JustinDS89, Apr 24, 2018

Share This Page