1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura Problem solved

Discussion in 'Troubleshooting' started by Lance Weston, Aug 2, 2023.

  1. Lance Weston

    Lance Weston Active Member

    Jun 2, 2018
    Likes Received:
    I have been going nuts for awhile unable to recreate quality prints that I was doing a couple of years ago. I was up to version 5.4.0. After banging my head against the wall for a couple of months I reinstalled Cura 4.2.1. and gone were all of the stupid routings that were leaving holes/detents in the outer surface. I am now back to where I was, printing good parts. I have not yet traced to the version where the change took place and may just stay with what works.

Share This Page