1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura version for best Print.

Discussion in 'Software' started by Lance Weston, Sep 19, 2023.

  1. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    674
    Likes Received:
    235
    I was printing parts very well and they got worse. Mostly I saw dimples on the outside of my parts. I finally traced back to the version of Cura that gave me good prints and past which I could not get good prints. Cura version 4.1.2 beta is the last version that gives me good prints.

    As I look at the routing of versions past 4.1.2, I often get travels with multiple retractions from the same point on the outer surface. The confluence of these points leaves a dimple. The dimple turns into a vertical depression.

    This does not happen with every part, but it happens with a lot of them.
     

Share This Page