1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Cure: no supports being printed?

Discussion in 'Troubleshooting' started by PACNOR RC AEROSYSTEMS, Feb 4, 2016.

  1. PACNOR RC AEROSYSTEMS

    PACNOR RC AEROSYSTEMS Member

    Joined:
    Jan 2, 2016
    Messages:
    106
    Likes Received:
    18
    So, I have Support Type: Everywhere selected and all it's doing is printing the outlines and infil but no supports?
     
    #1 PACNOR RC AEROSYSTEMS, Feb 4, 2016
  2. afat08

    afat08 Member

    Joined:
    Jan 9, 2016
    Messages:
    38
    Likes Received:
    2
    What do you have your "Expert Config" set at (the three "..." button next to it)?
     
    #2 afat08, Feb 5, 2016
  3. PACNOR RC AEROSYSTEMS

    PACNOR RC AEROSYSTEMS Member

    Joined:
    Jan 2, 2016
    Messages:
    106
    Likes Received:
    18
    1.PNG
     
    #3 PACNOR RC AEROSYSTEMS, Feb 6, 2016
  4. afat08

    afat08 Member

    Joined:
    Jan 9, 2016
    Messages:
    38
    Likes Received:
    2
    Layout looks different from mine, but the support settings appear to be the same and I have no problems with printing supports so this is beyond my scope...
     
    #4 afat08, Feb 8, 2016
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #5 mark tomlinson, Feb 8, 2016

Share This Page