1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Differential IR height sensor

Discussion in 'Troubleshooting' started by regor, Jul 4, 2016.

  1. regor

    regor Member

    Joined:
    May 20, 2015
    Messages:
    51
    Likes Received:
    7
    Is there anyone that knows how to set up the David Crocker differential IR height sensor on the Robo R1? Like where wires from the output (3 pin connector) actually go on the ramps board and what do you have to do with any configuration code on the arduino board? Any step by step method for this old guy would be appreciated.
     
    #1 regor, Jul 4, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #2 mark tomlinson, Jul 4, 2016
  3. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    I installed and did the firmware update for it. Made a mount for it as well. The link above has my notes on it, but more than happy to help you out if you have additional questions. Great upgrade.

    The one Jim did is almost spot on to Dave's. Both are great
     
    #3 danzca6, Jul 4, 2016

Share This Page