1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved During print Z axis stops going up

Discussion in 'Troubleshooting' started by Ryan Sampey, Jan 20, 2015.

Thread Status:
Not open for further replies.
  1. Ryan Sampey

    Ryan Sampey New Member

    Joined:
    Jan 20, 2015
    Messages:
    8
    Likes Received:
    3
    During my prints the Z axis will stop going up for more layers and decides to print them all at one layer height at random which ends up in a lot of scraping noise and plastic being pushed off of the print. How can I fix this?
     
    #1 Ryan Sampey, Jan 20, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    You may need to lubricate your threaded rods with something like lithium grease spray or superlube
     
    #2 Mike Kelly, Jan 20, 2015
Thread Status:
Not open for further replies.

Share This Page