1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

End of print lowers head into the object

Discussion in 'Troubleshooting' started by Denys Dmytriyenko, Jan 18, 2014.

Thread Status:
Not open for further replies.
  1. Denys Dmytriyenko

    Denys Dmytriyenko Active Member

    Joined:
    Nov 29, 2013
    Messages:
    119
    Likes Received:
    59
    Does anyone know what Repetier setting can cause the head to get lowered at the end of the print right into just printed object, ruining it in the process? It seems to be related to the "dump area" in the Repetier Host, but instead of moving away from the object and then lowering the head, it first lowers the head into the object and then moves away. Not nice. I disabled "go to the dump area at the end" to workaround the issue, but is it a known bug or some other setting? Thanks.
     
    #1 Denys Dmytriyenko, Jan 18, 2014
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    That's an issue from the firmware. It's been updated in the marlin firmware.
     
    #2 Mike Kelly, Jan 18, 2014
  3. Melody Bliss

    Melody Bliss New Member

    Joined:
    Nov 17, 2013
    Messages:
    276
    Likes Received:
    81
    Denys, as Mike said, it's a bug in the older firmware. You should update to the current version of Marlin.

    Take a look at section B.9. in the Robo 3D User's FAQ which can be found at http://melodybliss.org/robo3d/
     
    #3 Melody Bliss, Jan 18, 2014
Thread Status:
Not open for further replies.

Share This Page