1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Extruder Home Position

Discussion in 'Troubleshooting' started by Jaak Ahelik, Sep 10, 2017.

Thread Status:
Not open for further replies.
  1. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    IMG_8761.JPG Before to print, the extruder makes terrible noise at home position, how to change the position? Those two parts are too close to each other and produce the noise.
     
  2. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    Look at the home switch and the part that's supposed to press it, see if they're aligned and correct if necessary.
     
    Jaak Ahelik likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,729
    Likes Received:
    2,330
    Did the bolt fall out that engages the home switch ? Not a good photo
     
    Jaak Ahelik likes this.
  4. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    Those two parts get too close. There is no distance between. They start vibrate.
     
  5. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    Again, check the switches are pressed by the rods. If not move the rods until they do.


    Clipboard01.jpg
     
    OutsourcedGuru, Jaak Ahelik and Geof like this.
  6. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    Thx, I'll try it tonight
    Thank you, problem solved.
     
    OutsourcedGuru and Geof like this.
Thread Status:
Not open for further replies.

Share This Page