1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Extruder takes a step back along the X-Axis.

Discussion in 'Troubleshooting' started by TheMadTitan, Jan 28, 2015.

Thread Status:
Not open for further replies.
  1. TheMadTitan

    TheMadTitan New Member

    Joined:
    Nov 10, 2014
    Messages:
    5
    Likes Received:
    0
    When the extruder makes its way to the positive side of the x-axis it takes a quick, small step back then keeps going, like a stutter step. But you can see where it happened in my prints. I'll upload a picture of a print later but I'm hoping someone knows what might be causing this right off the top. I have the R1.
     
    #1 TheMadTitan, Jan 28, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    If you print a circle does it come out off shaped? Might be a loose pulley/belt from your description.

    Pictures speak 1000 words
     
    #2 Mike Kelly, Jan 28, 2015
Thread Status:
Not open for further replies.

Share This Page