1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Filament Shuttle

Discussion in 'Show and Tell' started by tkoco, May 2, 2019.

  1. tkoco

    tkoco - -.- --- -.-. ---
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    721
    Likes Received:
    273
    A filament separator to assist the C2 printer with pulling filament from a spool. You slide one of these onto the filament before you feed the filament to the printer. The shuttle hangs as shown and is self-positioning. The flat side faces the spool. The ridged side faces outward (just like you see in the image)

    The model was created in FreeCAD. The model was sized for 1.75 mm filament (like on the C2 & R2 printers)

    shuttle.jpg
     

    Attached Files:

    #1 tkoco, May 2, 2019
    Last edited: May 2, 2019
    mark tomlinson likes this.

Share This Page