1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Fill Density

Discussion in 'Off Topic' started by Hellsbells, Feb 4, 2015.

  1. Hellsbells

    Hellsbells New Member

    Joined:
    Feb 1, 2015
    Messages:
    27
    Likes Received:
    4
    I am new to the Robo 3D and was curious what everybody sets the fill density for ABS?
     
    #1 Hellsbells, Feb 4, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Depends on how strong want the part to be. Usually around 10-50%
     
    #2 Mike Kelly, Feb 5, 2015
  3. k1e1v1i1n

    k1e1v1i1n Active Member

    Joined:
    Dec 11, 2014
    Messages:
    230
    Likes Received:
    73
    I almost always use 30% as a minimum. less can leave holes if everything else isn't set up right.
     
    #3 k1e1v1i1n, Feb 5, 2015

Share This Page