1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Fine tuning fine printing

Discussion in 'Off Topic' started by mark tomlinson, May 25, 2018.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,643
    Likes Received:
    7,239
    Interesting video:

     
    DrOldies and bill Snyder like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,643
    Likes Received:
    7,239
    Still like our resin printer for the really small stuff :) But we have gotten quite passable results on the Robos
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,643
    Likes Received:
    7,239
    The presenter is a bit annoying to watch, but he does get the basics covered :)
    Any of these FDM printers with stock hardware and nozzles can do really decent prints.
     
  4. DrOldies

    DrOldies New Member

    Joined:
    Jun 10, 2018
    Messages:
    1
    Likes Received:
    0
    While this video is dated, showing lots of models up close is very helpful. Most videos show them from several feet away. Including a number of settings and the results will save lots of time.
     

Share This Page