1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Gcode for lifting nozzle

Discussion in 'Troubleshooting' started by cosber, May 8, 2015.

  1. cosber

    cosber Active Member

    Joined:
    Jun 20, 2013
    Messages:
    300
    Likes Received:
    87
    I have the gcode for lifting the nozzle after the last autoprobe using Simplify3d which worked fine. Within the last few weeks though, the nozzle lifts as it should but then drops back down before moving to the beginning of the print. I know I haven't changed anything and don't recall any software upgrades lately. Is there another piece of code somewhere that might be effecting it?
     
    #1 cosber, May 8, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Hard to say without seeing your code
     
    #2 Mike Kelly, May 8, 2015

Share This Page