1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Gears jam

Discussion in 'Troubleshooting' started by Khurram Ali, Sep 13, 2014.

Thread Status:
Not open for further replies.
  1. Khurram Ali

    Khurram Ali Member

    Joined:
    Jan 19, 2014
    Messages:
    32
    Likes Received:
    2
    It seems like the gears make a jamming noise when its on the left side. It doesn't print correctly when it is making that noise. Has anyone experienced it?
     
    #1 Khurram Ali, Sep 13, 2014
    2 people like this.
  2. Andreas Nicholas

    Andreas Nicholas New Member

    Joined:
    Feb 20, 2013
    Messages:
    34
    Likes Received:
    12
    That is currently my problem-dejour as well
     
    #2 Andreas Nicholas, Sep 18, 2014
  3. Andreas Nicholas

    Andreas Nicholas New Member

    Joined:
    Feb 20, 2013
    Messages:
    34
    Likes Received:
    12
    I noticed pinching the white shrink tubed part of the red blue green black made it go away, now if I can only get the extruder to continuously flow!
     
    #3 Andreas Nicholas, Sep 18, 2014
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Sounds like you found a loose connection under the heat shrink. Good job.
     
    #4 mark tomlinson, Sep 18, 2014
Thread Status:
Not open for further replies.

Share This Page