Heat bed will not heat

I started a print yesterday, everything went great until laptop battery died. This has happened to me before. This time, after starting again the bed temp would not go up even after 20 minutes. I shut everything off for the rest of the day. This morning still can not get the bed to go up in temp. The printers lights are on just like before, nothing seems to be different. Can anyone help?

 

Can you measure the voltage coming off of D8?

 

Yes, I will get my meter.

 

I have 12.24 volts.

 

ok now measure the resistance of the heat bed.

Also verify the thermistor is pressing against the kapton heater.

 

Now I don't have any power to the board.

 

The white wire has gotten hot and melted the plastic end of the plug into heat bed. The plug on the bed is ok.

 

Sounds like that's your problem then.

 

The resistance in the bed was good.

 

Around 1.5ohms?

 

I still dont have power to the board?

 

1.2ohms

 

Can you take a picture of how it melted? Would you chat with me over skype? would help with communication: redacted

 

I will but you may have to walk me thru it. I have never used it before.

 

it's just a chat messenger. it's like this but without me replying to the forum.

 

Let me know if this pic is good enough. If not I will take another one.

 

Ok get a technical support request going here: http://www.robo3dprinter.com/pages/technical-support

They'll need to send you a replacement connector it appears.

 

Did you get the message over skype?

 

nope you need to send me a contact request first

 

I sent it, If that doesn't work, I am still havng issues with no power.