1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Heated bed heats to temp but then stops?

Discussion in 'Troubleshooting' started by Kevin Sheridan, Aug 3, 2014.

Thread Status:
Not open for further replies.
  1. Kevin Sheridan

    Kevin Sheridan New Member

    Joined:
    Jun 7, 2014
    Messages:
    14
    Likes Received:
    2
    My heated bed heats to 55 degrees like normal but then It will slowly cool to 45 and some times 40 degrees. It seems to have started when I updated matter control and my printer firmware.
     
    #1 Kevin Sheridan, Aug 3, 2014
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Is there a fan on your ramps board?
     
    #2 Mike Kelly, Aug 4, 2014
  3. Kevin Sheridan

    Kevin Sheridan New Member

    Joined:
    Jun 7, 2014
    Messages:
    14
    Likes Received:
    2
    Sorry, I was away for a week.

    Yes there is a fan on my ramps board and it is running
     
    #3 Kevin Sheridan, Aug 10, 2014
Thread Status:
Not open for further replies.

Share This Page