1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hello, First Time User From Las Vegas!

Discussion in 'United States of America' started by StaticPain, Feb 8, 2016.

  1. StaticPain

    StaticPain New Member

    Feb 8, 2016
    Likes Received:
    Super excited about having a 3d Printer. Been interested in these for a couple of years and now I got one of my own! Got my unit from the CES 2016 here in Las Vegas.

    Had a small hiccup when first setting her up. She kept moving up on the Z axis when calibrating and printing into thin air, ended up with some spaghetti before stopping the print. But after some research and a helpful YouTube video I was able to fix it by adjusting the rod until it hit the switch. Found Here:

    First print I did was the circle,

    and now It's printing out the top spool feeder! I figure I'll print out the basic helpful things recommended in a couple YouTube videos and go from there. Found Here:

    Looking for any other recommended videos or reading for a new user. Thanks!
    #1 StaticPain, Feb 8, 2016
    Last edited: Feb 8, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Feb 21, 2013
    Likes Received:

Share This Page