1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hello from Alexandria, VA

Discussion in 'United States of America' started by WZ9V, Apr 10, 2016.

  1. WZ9V

    WZ9V Active Member

    Joined:
    Apr 9, 2016
    Messages:
    218
    Likes Received:
    64
    Just got a R1+ from MicroCenter yesterday.

    Prints are surprisingly good out of the box using MC 1.5 on my Linux box but I can tell some tuning is needed. Any pointers or FAQs?
     
    #1 WZ9V, Apr 10, 2016
  2. WZ9V

    WZ9V Active Member

    Joined:
    Apr 9, 2016
    Messages:
    218
    Likes Received:
    64
    Printed the test circle, needed to adjust X level
    Printed a 3DBenchy, not bad for out of the box settings
    Printed a set of raised feet, default infill in MC left some gaps. Re-Printing some new ones.
    Ball bearing spool holder up next, then a Smart XXL Display

    Gotta get Slic3r and Pronterface setup, MatterControl GUI is just not for me.
     
    #2 WZ9V, Apr 11, 2016
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I missed this post! My apologies and welcome!
     
    #3 Geof, Apr 29, 2016

Share This Page