1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hello

Discussion in 'United States of America' started by Captain McGillacutty, Feb 20, 2016.

  1. Captain McGillacutty

    Captain McGillacutty New Member

    Joined:
    Feb 12, 2016
    Messages:
    12
    Likes Received:
    0
    Just bought my first 3D printer 2 weeks ago. I can say the Robo was the right choice, entry price was good and enough to tinker with and upgrade to really start learning. I am very much looking to finally be able to prototype my ideas and not pass a good idea up again. The knowledge base on this site has been more helpful than I can say. Hopefully I will be able to give some back as well.
     
    #1 Captain McGillacutty, Feb 20, 2016
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    Welcome!
     
    #2 Mike Kelly, Feb 23, 2016

Share This Page