Unresolved Holes after changing pla brand

I am getting holes in my prints with the Robo3D blue which comes with the printer. I did pickup a roll at the retailer while getting the printer that roll is made by Shaxon, and it does not get holes. The purchased one i use E is at 190-200 B 50 usually works great. Changed over to the Robo3D blue and kept same temps but i get holes as seen in pic. I updated the temp same problem, now i fell it is lack of flow for this brand of plastic. Am I on the right track? photo

 

It's not the best quality filament. Increasing the number of top layers will seal up those holes

 

Thanks for the replys guys. I am probably goin to toss out the blue included with printer.