1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Home issues.

Discussion in 'Troubleshooting' started by Gabriel Moore, Nov 29, 2015.

  1. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    The Y axis s only moving one way when printing and setting home position. But it works fine when I move it through the XXL Lcd. I had just finished a print, removed it, Cleaned the bed and started this next print. Powered off the printer and waited, powered it back on and sam issue.

     
    #1 Gabriel Moore, Nov 29, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Check the Y axis home switch (under the bed) and make sure it is working correctly.
    (check the wiring to/from it as well)

    It should activate when HOMED only.
     
    #2 mark tomlinson, Nov 29, 2015
  3. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    I turned it on this morning and it worked. I'm at a loss. I did check the cables and it looked like they were fine. But now it's working.
     
    #3 Gabriel Moore, Nov 29, 2015
  4. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    Take it back. The lcd home function worked. The print did the same issue as before. Now I'm really confused.
     
    #4 Gabriel Moore, Nov 29, 2015
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Did you check the home switches for the X and Y?
     
    #5 mark tomlinson, Nov 29, 2015
  6. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    I did. I just disconnected the xxl lcd and plugged into my mac. All is working. I'm going to finish the calibration print and plug the lcd back in and format the SD card. Maybe corruption. Or lcd failure.
     
    #6 Gabriel Moore, Nov 29, 2015
  7. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    After doing a calibration ring on the mac. Hooked the lcd back up. Fresh format on the sd card. All is working again. Crazy problems I have been having this weekend.
     
    #7 Gabriel Moore, Nov 29, 2015
    mark tomlinson likes this.
  8. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Roll with it :)
     
    #8 mark tomlinson, Nov 29, 2015
    Gabriel Moore likes this.

Share This Page