1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Horrible z banding or something

Discussion in 'Troubleshooting' started by mclemens7, Aug 27, 2017.

  1. mclemens7

    mclemens7 Member

    Joined:
    Jan 29, 2017
    Messages:
    165
    Likes Received:
    6
    I woke up this morning after running a print and I opened the door to this. Something is wrong with the printer. This was supposed to be a straight screw. As you can see it’s not. For mods on my printer I have put an e3d v6 hotend on it. Any thoughts and fixes??
     
    #1 mclemens7, Aug 27, 2017
  2. mclemens7

    mclemens7 Member

    Joined:
    Jan 29, 2017
    Messages:
    165
    Likes Received:
    6
    Here is the print
     

    Attached Files:

    #2 mclemens7, Aug 27, 2017
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Looks like your printing to hot (if upright) or dont have a well tuned machine and need to go back to test prints to dial it in. If your printing it laying down and its turning out like that ...well .... its just going to...turn on supports.
     
    #3 Geof, Aug 28, 2017

Share This Page