1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered How Can I Improve This? Part IV

Discussion in 'Troubleshooting' started by Jimmy Husain, Dec 15, 2015.

  1. Jimmy Husain

    Jimmy Husain Member

    Joined:
    Oct 16, 2015
    Messages:
    109
    Likes Received:
    16
    So here it goes. This is how it is in S3D.

    vwall.jpg

    Then this is what I get. How can I make the vertical wall better?

    vwall1.jpg

    vwall2.jpg

    vwall3.jpg
     
    #1 Jimmy Husain, Dec 15, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    That is overrun on whichever axis that is... I'd suggest slowing down the print speed for the small layers. You can do this in S3D. Simply set the minimum layer time higher and it will automatically slow down on small layers.
     
    #2 mark tomlinson, Dec 15, 2015
    Jimmy Husain likes this.
  3. Jimmy Husain

    Jimmy Husain Member

    Joined:
    Oct 16, 2015
    Messages:
    109
    Likes Received:
    16
    I bet its in this window?

    Untitled.jpg
     
    #3 Jimmy Husain, Dec 15, 2015
    mark tomlinson likes this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    You win that bet :)

    Change that from 15 seconds to something longer (start with 60 seconds) and see where you get best results. You could probably fix it by playing around with acceleration and speeds, but since it is only happening on smaller layers just slow down for those.
     
    #4 mark tomlinson, Dec 15, 2015
    Jimmy Husain likes this.
  5. Jimmy Husain

    Jimmy Husain Member

    Joined:
    Oct 16, 2015
    Messages:
    109
    Likes Received:
    16
    Haha~ Thanks mark. I'll give it a go & hope it gets better.
     
    #5 Jimmy Husain, Dec 15, 2015
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Should work, let me know. I had a model that was large with a tiny set of layers coming up like that... there is where I learned about slowing down for small layers :) You can also increase the fan speed for smaller layers (same screen) which can also help.
     
    #6 mark tomlinson, Dec 15, 2015
  7. Jimmy Husain

    Jimmy Husain Member

    Joined:
    Oct 16, 2015
    Messages:
    109
    Likes Received:
    16
    I will for sure update you later during the day. Right now I got something else printing. Will try printing the same model again with the new settings.
     
    #7 Jimmy Husain, Dec 15, 2015

Share This Page