1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Improvement for the C2 and R2 printers

Discussion in 'Community Recommendations' started by tkoco, Jun 22, 2018.

  1. tkoco

    tkoco Administrator
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    278
    Likes Received:
    131
    The Robo magnetic cover plate for the hot end blocks the airflow from the cooling fan.

    Suggestion: Use a perforated cover plate to allow the cooling air to flow through it, but still protect fingers from touching the hot end.
     
    mark tomlinson likes this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,530
    Likes Received:
    7,061
    Not a bad idea. I haven't had any real issues with it on my C2 even with two extruders in there going to town, but it is still not a bad idea. More airflow around the cooling fins can't be bad.
     

Share This Page