1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Is my print okay? Please help!

Discussion in 'Troubleshooting' started by Marc Alcarese, Jan 1, 2015.

Thread Status:
Not open for further replies.
  1. Marc Alcarese

    Marc Alcarese New Member

    Joined:
    Dec 31, 2014
    Messages:
    12
    Likes Received:
    0
    image.jpg image.jpg Hi, I just received my Robo 3d printer yesterday. The first thing I printed was the calibration box and it looked great so then the next day I came back and printed another one. This time it doesn't look as good. image.jpg
    There are little blobs on the top. It looks as if the printer was scraping the top while printing. Any tips for a newbie at 3d printing? Also can I use any other program besides MatterControll?
    Also what is with the side of the cube?
     
    #1 Marc Alcarese, Jan 1, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Yeah it looks good. That issue might be curling or something else, some hiccup that probably isn't normal.

    Make sure your nozzle is tight
     
    #2 Mike Kelly, Jan 1, 2015
    Last edited by a moderator: Jan 1, 2015
Thread Status:
Not open for further replies.

Share This Page