1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Leaning Tower of Pisa

Discussion in 'Troubleshooting' started by Island Bill, May 9, 2015.

  1. Island Bill

    Island Bill Active Member

    Joined:
    Aug 1, 2014
    Messages:
    132
    Likes Received:
    76
    I'm not sure if this is the printer or maybe I need new glasses, but it seems that a print which is round and 31mm high has an ever so slight lean to X0. Is this something anyone else has experienced?
     
    #1 Island Bill, May 9, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    No, and I have printed some tall ones.
    If it really is offset maybe a loose belt or drive gear.
     
    #2 mark tomlinson, May 9, 2015
  3. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    I agree with Mark. A tall print should be straight all the way up. If it is angled or off then it was most likely a loose belt or drive gear. Also could be a possible overheating ramps board that caused it to miss a step. Check all of these things.
     
    #3 jbigler1986, May 9, 2015

Share This Page