Marlin for the R2 - MESH Enabled

Do not use the Z Offset wizard after enabling and activating the MESH. The RoboOS wizard appears to reset all printer memory settings to the firmware defaults, thus invalidating any leveling method you may have used.

 

Found a bug in RoboOS, every time you start up the printer it resets all of your EEPROM settings to firmware defaults. This is stupid and should not be there. It dumps you valid mesh and any other EEPROM setting, such as PID tuning.

 

Working on 1.1.8, expect some new files soon. Not sure if any of the commits beyond 1.1.7 affect the R2 but might as well be up to date.