1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

microSD card holder for re-insertion into C2

Discussion in 'Show and Tell' started by OutsourcedGuru, Feb 10, 2018.

  1. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    139
    Okay, so it's somewhat easy to pull the microSD card out of a Robo C2 but I've found it to be a pain to try to coax it back in. The spacing is such that you can barely get your hand in there, the angles make it tough to align the card in a horizontal plane, etc.

    This little part then allows you to grab the microSD, align and insert it without too much extra effort. The print job takes a mere six minutes to print and requires no brim/raft/support.

    IMG_0439.png IMG_0441.png
     

    Attached Files:

    jimmy1967 and mheath82 like this.
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,817
    Likes Received:
    3,539
    So where is the tool to pull the µSD card out of the rPi?
     
  3. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    139
    hands.jpg
     
    jimmy1967 and tkoco like this.
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,817
    Likes Received:
    3,539
    If they are articulated I'll take 10!
     
  5. Stephen LaRochelle

    Stephen LaRochelle New Member

    Joined:
    Mar 1, 2017
    Messages:
    3
    Likes Received:
    2
    Very helpful. Thank you!
     
  6. tkoco

    tkoco Administrator
    Staff Member

    Joined:
    May 7, 2018
    Messages:
    216
    Likes Received:
    110
    Nice to see that you have a good sense of humor :D <Reference image of hands upon hand>
     

Share This Page