My First Successful Print

Big thanks again to everyone that have taught me little things here and there. I just completed my first successful print. Took 2.5 hrs. Now to do the other half of it. It will be a filament holder that will put the spool directly above the robo instead of off to the side. Now for the tricky part... remove it off the bed

Image of What it will do... (Not my image, took off internet)

 

Second Half Nearing Completion.

 

Anyone know what causes this... Should I print some z-axis stabilizers and see if that helps

 

What cooling settings are you using? Are layers swelling and being mashed by subsequent layers? If so this would be typically be too little cooling for layers that have a short print time. Look at the auto cooling settings carefully.

 

These are my settings. Would this be considered running too hot


Completed Project

 

Mine personally is set with enable auto cooling checked, min fan speed to 35, and min print speed at a much slower 3.
You could try and see if that makes a difference. Seems to work well on mine at least.