1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved my printer is really clogged... help

Discussion in 'Troubleshooting' started by alastair kinworthy, Apr 6, 2021 at 9:19 AM.

  1. alastair kinworthy

    alastair kinworthy New Member

    Joined:
    Tuesday
    Messages:
    1
    Likes Received:
    0
    what do i do if this happens (picture)
     

    Attached Files:

  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,044
    Likes Received:
    7,273
    Heat up the hotend to ABS temps (240c or so) and use a hemostat or needle nose pliers to pull the filament off of the heater block.

    While hot you can use a small wire brush or a towel to (carefully -- hot) wipe off the rest of the plastic residue.
     
    #2 mark tomlinson, Apr 6, 2021 at 10:20 AM
    Last edited: Apr 6, 2021 at 11:00 AM

Share This Page