1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved My R1 turned off and won't turn back on

Discussion in 'Troubleshooting' started by sofiadragon1979, Dec 9, 2014.

Thread Status:
Not open for further replies.
  1. sofiadragon1979

    sofiadragon1979 Member

    Joined:
    Nov 5, 2014
    Messages:
    34
    Likes Received:
    10
    I was removing a piece from the bed that I had just spent most of the evening printing & getting ready to print something else when the unit turned off for no reason & now it won't turn back on, I have already taken the bottom off & checked to make sure that everything is connected & it appears to be so but it still won't turn on. Please help me w/ this ASAP.
     
    #1 sofiadragon1979, Dec 9, 2014
  2. Brad T

    Brad T New Member

    Joined:
    Nov 17, 2014
    Messages:
    17
    Likes Received:
    9
    Sounds like the power supply. Do any of the lights turn on?
     
    #2 Brad T, Dec 9, 2014
  3. sofiadragon1979

    sofiadragon1979 Member

    Joined:
    Nov 5, 2014
    Messages:
    34
    Likes Received:
    10
    None of the lights turn on @ all. And you were thinking on the same wave length that I am.
     
    #3 sofiadragon1979, Dec 9, 2014
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Might be the fuse in the switch, pop that thing out and take a look.
     
    #4 Mike Kelly, Dec 9, 2014
  5. Brad T

    Brad T New Member

    Joined:
    Nov 17, 2014
    Messages:
    17
    Likes Received:
    9
    Switch would have been my next step. Break out the multimeter!
     
    #5 Brad T, Dec 9, 2014
Thread Status:
Not open for further replies.

Share This Page