1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Need Controller Board Photo With Connections

Discussion in 'Troubleshooting' started by Harrison3.14159, May 9, 2015.

  1. Harrison3.14159

    Harrison3.14159 New Member

    Joined:
    May 9, 2015
    Messages:
    1
    Likes Received:
    0
    Hi,
    Robo3d removed my bed heater and cables and returned the printer to me without the new parts. The parts came in the mail and I have installed the heater film to the bed. However, I don't know the connections for the wires to the controller board so a picture of the connections would help greatly. I need to know where the heater strip two wires connect and the thermistor wire connects. Also the small fan connector that is attached to the bottom panel fan came off with the panel and I don't know which pins on the controller board it connects to. The Model is R1. Thank you!
     
    #1 Harrison3.14159, May 9, 2015
  2. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    Here you go. Thanks to Mike Kelly for the picture.
    [​IMG]
     
    #2 jbigler1986, May 9, 2015
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Yep that is the picture.
    the case fan goes on the one labeled 12v Aux (connector to the right of the polyfuses and D2 in this picture).
    Frankly you can re-land it on the 12v power main the way this picture shows as well (but it already has the connector for the 12v Aux plug)
     
    #3 mark tomlinson, May 9, 2015

Share This Page