Need Help Installing Dual Fan Mod on Robo R1

Hello everyone, really looking for some info. on installing a Dual Fan Mod on my Robo R1 like in the following YouTube video by Novice Expert " Expert Mods: Dual Coolers Mod"
(I think he's a member here as well) using his Dual Fan Ducts design for the E3D V6 hotend. Well my only thing is were exactly do you wire in the fans into the Ramps Board and also can you use a wire/connector to the factory 40mm fan that come stock with the Robo R1 or do you have to re wire the Dual Fans, both fans will be 40mm 12v?! Thanks in advanced, I appreciate it!

 

What I did was buy a set of these: http://www.amazon.com/Pins-Wire-Bat...Hk1lrtL&dpSrc=sims&preST=_AC_UL160_SR160,160_

Then make a Y cable with 1 male and 2 female. This runs the fans in parallel and you can just replace the connector on your new fan with one of those, then plug the stock fan into the other port. Pretty easy

 

Awesome thanks for the great advice Mike Kelly, where on the Ramp Board would they plug into? Do you have a wiring diagram of the board showing where to plug them in. If you do I would highly appreciate it. Thanks!

 

Don't bother running it back to the ramps board. Just unplug the connector from the stock fan and plug it in there

 

Awesome, will do. Thanks!